Duts87ss
06-29-2006, 07:54 AM
It's best to get in touch with my by emailing duts87ss@yahoo.com
PowerMaster 10SI (like factory) 140amp alternator - $130 shipped - removed when I did my serpentine swap. I think I bought it around a year and a half ago, but it has very little miles as it's not a daily driver and I've been rebuilding the suspension and working on a TPI swap. It has well under 10k miles and probably under 5k. It will come with the Vbelt pulley that it came with from PowerMaster. The dyno card that came with it rated it at over 90amps at idle and over 150amps max.
http://store.summitracing.com/partdetail.asp?autofilter...94880694+115&autoview=sku (http://store.summitracing.com/partdetail.asp?autofilter=1&part=PWM%2D47294&N=4294908216+4294908176+4294925022+4294925143+4294 839060+4294880793+400345+4294880701+4294880694+115&autoview=sku)
KYB shocks - $75 shipped (all four)- pulled off my car when I rebuilt the suspension. The shocks are still hard to compress and rebound slowly on their own (like they should). I wouldnt recommend using the front shocks with a spring rated higher than stock; with my drop springs, the rebound and dampening was off a bit.
Edelbrock #1406 carb - $175 shipped - used, low miles, bought from Summit as an Edelbrock reman. part, has worked great. I also have the Edelbrock tuning kit for this carb and a couple extra sets of rods that I can deal on.
Mallory 85 series distributor - $110 shipped - installed same time as the carb, has Accell coil, excellent shape.
Weiand 8004 intake - $75 shippped - I can clean and paint it before it ships.
'87 SS ECM and PROM - $75 shipped.
'87 SS wiring harness - $35 shipped - transmission connector has been cut.
PowerMaster 10SI (like factory) 140amp alternator - $130 shipped - removed when I did my serpentine swap. I think I bought it around a year and a half ago, but it has very little miles as it's not a daily driver and I've been rebuilding the suspension and working on a TPI swap. It has well under 10k miles and probably under 5k. It will come with the Vbelt pulley that it came with from PowerMaster. The dyno card that came with it rated it at over 90amps at idle and over 150amps max.
http://store.summitracing.com/partdetail.asp?autofilter...94880694+115&autoview=sku (http://store.summitracing.com/partdetail.asp?autofilter=1&part=PWM%2D47294&N=4294908216+4294908176+4294925022+4294925143+4294 839060+4294880793+400345+4294880701+4294880694+115&autoview=sku)
KYB shocks - $75 shipped (all four)- pulled off my car when I rebuilt the suspension. The shocks are still hard to compress and rebound slowly on their own (like they should). I wouldnt recommend using the front shocks with a spring rated higher than stock; with my drop springs, the rebound and dampening was off a bit.
Edelbrock #1406 carb - $175 shipped - used, low miles, bought from Summit as an Edelbrock reman. part, has worked great. I also have the Edelbrock tuning kit for this carb and a couple extra sets of rods that I can deal on.
Mallory 85 series distributor - $110 shipped - installed same time as the carb, has Accell coil, excellent shape.
Weiand 8004 intake - $75 shippped - I can clean and paint it before it ships.
'87 SS ECM and PROM - $75 shipped.
'87 SS wiring harness - $35 shipped - transmission connector has been cut.