Hello all,
I have a rear end from a T-Type thats all ready for installation. Im running a 700 r4 transmission with my current set up (1981). Does anyone in here know what the length of the driveshaft should be from yolk to yolk for the install?

the best bet is to install everything and take a measurement. Then you know for sure what it needs to be in your particular camino. Be sure and allow at least an inch for the yoke to travel on the tranny output shaft.

You can go to the Inland Empire driveline site, and they tell you how to measure if ordering a new shaft, which is the info you are looking for.