Thinking about getting rid of my tuned port injection setup that I've been using in my el camino. Really nice and comes complete with stand alone harness and custom 4 inch intake. Clean setup with new distributor and good 24 pound injectors and also has fuel rail converted to an lines for better fit in gbody. Good clean setup painted black and comes with everything to use it. Would like to get $600 for whole setup ready to bolt to your engine.

Just tryin to see if there is any interest on here

Mike bump this up again early tomorrow then if you don't get any feelers or takers, try posting it here.
http://www.thirdgen.org/
That sounds like a decent set-up why are you selling it?I'm just curious.

Just not interested in the setup anymore. I will bump tomorrow but will not post on that site. I have been a member for a while and I must say most people I've delt with on there come off as rude.bthanks for the input though

Allso have a 350 engine out of a mid 70s engine I would like to get rid of for $200 obo, could use simple rebuild

Have you tried www.maliburacing.com (http://www.maliburacing.com) or http://gbodyforum.com/viewforum.php?f=5 I'm not a member on either one but I'll cruise overthere once in a while and found some good info and from what I've read they seem to be civil and just as willing to help you like the people on here as long as nobody gets rude with them. Keep in mind what you read is not always ment the way it sounds when you read it,sometimes it is but not always.I hope this helps.

Yyup have a Malibu and am on there daily

Might also try montecarloss.com. There are a few guys there that have converted, and some more looking. I know from experience that a "Very Complete" system, with harness, sensors and new injectors, will cost a lot more than you are asking, so I would "Bump" this for being a reasonable price. Mine cost way more than that by the time I got finished replacing all the bad parts.

What else would be needed? I have a 1980 with 305 and 4 barrel.

Jack

If you have centerbolt heads it will bolt rite up and all you would need is to install it.

No idea what center bolt heads are. Engine is from a 1984 C10 PU.

Centerbolt would mean that your valve cover bolt up to the head in the center rather than parameter bolt like most older chevy engines. The most destinctive way to find out is to look at the valve covers, if the engine is center bolt then the valve cover will have 4 bolts in a row on top the valve cover

Can you post a picture or two of the setup please?

here ya go. also those valve covers are for sale by themselves as well.

http://i56.tinypic.com/4uwenq.jpg