I'm seen the advertisment, but can't find any info including on their web site. Summit wants around 1300.00 for it. Seems it works on TPI, LT1 and I believe the LS1. BTW, I've been thinking about using an LT1 ECM/PCM on a TPI. I believe I can get past the opti-dizzy problem. This might be another aproach.

Bill

If thats for the wiring & computer alone, it seems way high. Have you looked at the Holley Commander 950 Series controllers?

Will either one of those control the 4L60E trans?

From what I can tell, its just for the Wiring Harness and a programed ECM. It states its to be used envolving swaps using either a TPI, LT1 or LS1. No, I haven't checked out the Holley Commander completely. I thought it was a complete system. I'll have to see if the controller is compatible with a TPI.

As far as the 4L60E, Thats a good question.

Bill

http://www.holley.com/HiOctn/ProdLine/Products/C950/C950MPFI/C950EMSK.html is from the Holley Site & http://store.summitracing.com/default.asp?target=esearch.asp&N=100&Ntk=PartSearch&Ntt=hly-950-101&x=18&y=9 is from Summit.

You would need a laptop for tuning but I "THINK" that you would be happier than with a non-programmable ECU. They have a similar kit 950-102 or -103 for the LT1 motors. C950 does not control a tranny.

Thanks for the links, I'll check them out this week-end when I'm awake. Got a couple of Parent/Teacher Conferences at zero dark thirty in the morning.

Bill :sleepy: :sleepy: :sleepy: