El Camino Central Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
326 Posts
Discussion Starter #1
Does anyone know how to remove that piece of trim from a 4th gen? I have someone who wants the part, but I cannot figure out where the screws are located and I am afraid that I will have to remove the door panel. I would rather not if I can help it.

Thanks!
 

·
Deputy Director, Region 1
Joined
·
2,566 Posts
The belt molding? This is at the top of the door and has the weatherstrip that sweeps the glass. For this you need to remove the door panel and the lower window stop and bring the glass down below the molding. It's held on by small phillips screws, about 8 or so.
If you're talking about the chrome strip that seperates the 2 tone paint, there may be a small phillips or nut on the inside edge of the door at the front and back. The center of it should just be plastic clips. Pry upward carefully after removing any visible screw/nut at the edges.
 
1 - 2 of 2 Posts
Top