El Camino Central Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
72 Posts
Discussion Starter #1
I've seen in posts somewhere that someone used F-body spindles on a G-body to improve the geometry of the upper control arms. But I can't find any details. Basically all I've been able to find is a couple different people saying they used F-body spindles and a few other post arguing about if the ball joints have a different taper or not.

Has anyone here actually swapped F-body spindles on a G-body and have actually experience with it? If the swap is a real option, I was wanting to use F-body 2" drop spindles to lower the center of gravity while improving geometry.
 

·
Registered
Joined
·
645 Posts
Marketmerlin,

Check this site: Gbodyforum.com

I'm sure there is someone who has experience/knowledge with this swap in addition to a lot of good and useful information.
 
1 - 2 of 2 Posts
Top