El Camino Central Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I have a problem in which i need your help.

Hardware guy screwed up my original key when making a copy. I can't turn the ignition lock from the off position. I purchased replacement but instructions are horrible (poor pictures and very vague).

Please help me in getting the lock out to replace. I have steering wheel and turn signal out already and took off a plate to do that. Now i have another plate that i can not move or work around to get to the lock.

Please help!!


If anyone has a copy of a manual, pleases can and send to [email protected]. This might help and would be greatly appreciated.

Thanks in advance

Rick
 

·
Premium Member
Joined
·
6,026 Posts
Since you have the lock plate and turn signal switch out all that is left is one 7mm screw that runs down through the edge of the tumbler assy and it slides out.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top