El Camino Central Forum banner
1 - 3 of 3 Posts

· Registered
11,513 Posts
Discussion Starter · #1 ·
This may be a repeat, but this link is GREAT!!! The guy shows and tells (is a photo article) you how to cast your own parts from aluminum. Where to get the equipment, aluminum to melt down, and how to make the molds.

Don't panic! Only costs about $300 to set it all up and be ready to cast your first part. And not just thin wall decorative stuff either. This guy made a bellhousing to mate a T5 with a flathead!! You use broken intake manifolds, wheels, etc for the raw material.

Check this link out! What a great way to spend the winter when it's cold and snowy outside!!!

1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.