El Camino Central Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
578 Posts
Discussion Starter · #1 ·
I finally cleared some engine stands in my garage.
I have a couple engine blocks that need inspection and bore measurements.
They have both been sitting in a garage for years and have some rust in the cylinder bores...they are just blocks with cam bearings installed.
I want to clean up the cylinder walls and main caps and get some measurements.
Fine emery cloth?
Thanks guys.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top