El Camino Central Forum banner
1 - 11 of 11 Posts

·
Banned
Joined
·
555 Posts
Discussion Starter · #1 ·
86 Elcamino need to install Transmission Crossmember
Need help bolting in instructions
 

·
Premium Member
Joined
·
852 Posts
not quite sure what you are asking...........
 

·
Banned
Joined
·
555 Posts
Discussion Starter · #5 ·
Response 2 post

I slid trans crossmember aligned with holes in frame Now I NEED HELP TO BOLT THEM DOWN CORRECTLY
 

·
Registered
Joined
·
452 Posts
Sounds like April Fools to me !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
 

·
Deputy Director Region 6 - Supporting Member
Joined
·
6,209 Posts
Well one usually bolts them up from underneath and it is righty tighty. Again you may not be making your question clear enough for anyone to help. :dontknow:
 

·
Premium Member
Joined
·
5,974 Posts
the factory crossmember had a rubber bushing over the end of it and a cup that went over it with the bolt holes at the ends.
 

·
Registered
Joined
·
342 Posts
this is in an 86 cutlass with a v6, not sure if its exactly the same or not.
1st pic is passenger side 2nd is drivers side

 
1 - 11 of 11 Posts
Top